Are you someone who prefers raw power over battery life on your laptop? If you're tired of your system holding back to conserve energy, then this guide is for you.
Why Your Laptop Isn't Running at Full Speed
Most Linux distributions default to the powersave CPU governor. This setting helps extend battery life and keep your laptop cool, but it also limits performance. If you're a power user who demands the maximum performance from your machine, you might find this setting a bit too conservative.
How to Switch to Performance Mode
Ready to make your laptop roar? Here's how you can switch your CPU governor from powersave to performance mode.
Step 1: Check Your Current CPU Governor
First, let's see what mode your system is currently using. Open your terminal and run the following command:
cat /sys/devices/system/cpu/cpu*/cpufreq/scaling_governor
If your output looks something like this:
powersave
powersave
powersave
powersave
.
.
You're in powersave mode.
Step 2: Switch to Performance Mode
To unlock the full potential of your CPU, switch to performance mode by running the following command:
echo performance | sudo tee /sys/devices/system/cpu/cpu*/cpufreq/scaling_governor
Step 3: Verify the Change
After switching, it's a good idea to confirm that the change took effect. Run the first command again:
cat /sys/devices/system/cpu/cpu*/cpufreq/scaling_governor
If everything went smoothly, you should now see:
performance
performance
performance
performance
Step 4: Enjoy the Power
Congratulations, you've successfully switched to performance mode! Your laptop is now running at full throttle. Enjoy the extra speed and power—just be mindful of the increased energy consumption and heat.
Bonus Tip: Turbocharge Your Debian-Based Distro
If you're using a Debian-based distro and want to take your system's performance to the next level, be sure to check out this awesome repo: linuxbooster. It's packed with tools and tweaks to supercharge your Linux experience.
Top comments (0)